Furnace Repair Near Me — Same-Day Heating Repair in the Antelope Valley

    Gas furnaces, heat pumps and packaged units — dispatched from Lancaster

    Furnace repair near me in the Antelope Valley costs $185 to $895 flat-rate for the large majority of failures, with a $89 diagnostic that is waived when you approve the repair. The five most common furnace faults we find are a dirty flame sensor ($140–$240), a cracked hot-surface ignitor ($220–$420), a failed blower motor or capacitor ($385–$795), a blocked pressure switch or flue ($180–$520), and a failed control board ($450–$900). DC Air and Heating provides same-day furnace repair to Lancaster, Palmdale, Quartz Hill, Rosamond, Acton, Mojave, Santa Clarita and Canyon Country, with every repair backed by a one-year labor warranty.

    Key Facts

    • Same-day furnace repair, 7 AM–8 PM, seven days a week
    • $89 diagnostic waived with approved repair
    • Flame sensor, ignitor, blower, pressure switch, board — parts stocked on the truck
    • Carbon monoxide test on every heating call, no charge
    • One-year labor warranty
    • All brands serviced: Trane, Carrier, Lennox, Goodman, Rheem, York, Bryant
    Furnace problemTypical causeRepair cost
    Blows cold airDirty flame sensor / lockout$140 – $240
    Clicks but won't lightHot-surface ignitor$220 – $420
    Runs then shuts offOverheating / high-limit trip$185 – $495
    No air movementBlower motor or capacitor$385 – $795
    Won't start at allControl board or thermostat wiring$120 – $900
    Rumble or burning smellBurner / heat exchanger — stop useInspection required

    Estimated range only — get an exact written price with a free in-home consultation or use our Instant Quote tool. Get an Instant Quote or call (661) 310-3340.

    Takes 60 seconds

    Get your exact price in 60 seconds

    Skip the estimate range — our Instant Quote tool gives you a real Good/Better/Best price for your home, instantly. No phone calls. No pressure.

    Frequently Asked Questions

    How much does furnace repair near me cost?

    Most Antelope Valley furnace repairs run $185 to $895 flat-rate. Flame sensor cleaning or replacement is at the low end, control boards and blower motors at the high end. The $89 diagnostic is waived when you approve the work.

    Can you repair my furnace today?

    Usually yes. Lancaster, Palmdale and Quartz Hill calls booked before 4 PM are typically same-day; after-hours emergency dispatch is available with a $189 fee.

    Why is my furnace blowing cold air?

    The most common cause is a flame sensor coated in oxide, which shuts the gas valve within seconds of ignition while the blower keeps running. Other causes are a thermostat set to FAN ON, a pilot or ignitor failure, or a high-limit trip from a clogged filter.

    When should I replace instead of repair a furnace?

    If the furnace is over 15 years old, the repair exceeds $1,200, or the heat exchanger is cracked, replacement is the safer economic choice. A cracked heat exchanger is a carbon monoxide risk and we red-tag the unit.

    Do you check for carbon monoxide?

    Yes. Every heating service call includes a combustion and CO check at no additional charge, plus a visual heat exchanger inspection.

    Do you repair heat pumps as well as gas furnaces?

    Yes. We service gas furnaces, heat pumps, dual-fuel systems and packaged rooftop units, including defrost board and reversing valve failures specific to heat pumps.

    Keep Researching

    Hand-picked next steps based on this page's topic.

    Ready to get started?

    Free instant online quotes. Same-day service. Whatever it takes.

    SCHEDULE SERVICEQUICK QUOTE