Emergency Furnace Repair — No Heat Service, Same Night

    No-heat dispatch for gas furnaces, heat pumps and packaged units

    Emergency furnace repair is warranted when there is no heat and the overnight low is near or below freezing, when a carbon monoxide detector sounds, when you smell gas or a burning odor, or when the furnace trips its breaker repeatedly. DC Air and Heating dispatches emergency furnace repair across the Antelope Valley at (661) 310-3340; the after-hours fee is $189 and the repair is quoted flat-rate before work starts, typically $185 to $895. Before we arrive, shut the furnace off at the thermostat, leave the gas valve alone if you smell gas and get outside, and replace a visibly clogged filter — an overheated furnace locking out on its high limit is one of the most common no-heat calls we run.

    Key Facts

    • No-heat emergency dispatch, (661) 310-3340
    • Combustion and carbon monoxide test on every call, no charge
    • Ignitors, flame sensors, pressure switches and boards stocked on the truck
    • $189 after-hours dispatch; repairs $185–$895 flat-rate
    • Cracked heat exchangers red-tagged with same-day replacement options
    • Temporary safe-heat guidance while you wait
    SymptomLikely causeEmergency?
    Gas odorLeak at valve or unionYes — evacuate first
    CO alarm soundingCracked heat exchanger / flue blockageYes — call 911
    No heat, freezing outsideIgnitor, flame sensor, boardYes
    Furnace short-cyclesHigh-limit trip, dirty filterSame night if no heat
    Loud bang at ignitionDelayed ignition — unburned gasYes — shut it off
    Weak airflow, still warmFilter or blower wheelNo — next day

    Estimated range only — get an exact written price with a free in-home consultation or use our Instant Quote tool. Get an Instant Quote or call (661) 310-3340.

    Takes 60 seconds

    Get your exact price in 60 seconds

    Skip the estimate range — our Instant Quote tool gives you a real Good/Better/Best price for your home, instantly. No phone calls. No pressure.

    Frequently Asked Questions

    Do you do emergency furnace repair at night?

    Yes. Call (661) 310-3340 any hour. Standard service runs 7 AM to 8 PM daily; outside those hours a $189 emergency dispatch fee applies to the visit and diagnosis.

    How much does emergency furnace repair cost?

    $189 dispatch after hours plus the flat-rate repair, which is usually $185 to $895. Flame sensor and ignitor jobs are at the low end; blower motors and control boards at the high end.

    What should I do while waiting for emergency furnace repair?

    Turn the thermostat to OFF, check that the filter isn't clogged, and use only safe supplemental heat — never an oven or an unvented gas heater. If you smell gas or a CO alarm sounds, leave the house first and call from outside.

    Why did my furnace stop working in the middle of the night?

    The most common overnight failures are a flame sensor that has oxidized enough to lose signal, a hot-surface ignitor that cracked on a cold start, and a high-limit lockout caused by a clogged filter restricting airflow.

    Is a cracked heat exchanger repairable?

    No — it must be replaced, and on most furnaces over 12 years old the exchanger cost approaches a new furnace. We red-tag the unit for safety and quote both options the same visit.

    Do you service heat pumps on emergency no-heat calls?

    Yes. Heat pump no-heat calls are usually a failed defrost board, a stuck reversing valve, or auxiliary heat strips that have burned out — all handled on emergency dispatch.

    Keep Researching

    Hand-picked next steps based on this page's topic.

    Ready to get started?

    Free instant online quotes. Same-day service. Whatever it takes.

    SCHEDULE SERVICEQUICK QUOTE